Table of Contents
First Impressions
I am not affiliated with HE3D, but I enjoy creating short reviews on products that I use to print and build my 3D prints with. After seeing HE3D post their videos on social media about the moonlight diy circuit bored kit I 
instantly became very interested in doing this project. I had a lot of fun with the HE3D battery powered touch dual colored led circuit board.
First, the board comes shipped with the battery pack unplugged, this is for safety reasons when opening the package I was a bit worried that I was going to break off the LED
diode’s from the circuit board because the circuit board is not encapsulated, which also sparked my curiosity. I was concerned with touching it and ruining the LED diode’s or the circuit board, It looks very delicate.
But after spending some time messing around with the LED circuit board it was very clear that the LED circuit board was very sturdy and of a very high quality build.
When you plug in the included charger and a red light should come on, once the battery pack was fully charged the red light turned off and you’re ready to start checking all the function of the circuit board.
Once I unplugged the charger, I touched the charging port with my finger and the soft white light turned on to 100 percent, a quick tap and hold of that same port and the led started to dim. From what i can tell maybe it dim’s to 25 or 30 percent, next I release and tap again and the light turns from soft white to cool white.
Moon Light STL File
One more thing if you contact HE3D they might give you the STL file for the moonlight, which i needed for this review, I was not having much success with some models that i downloaded off of thingiverse.
Once i was able to fully print their moon light 3D model, it only took a second to put the circuit board in it’s proper place and glued the bottom of the moon to the top. I whipped up a quick STL file using fusion for a base that closely resembled the wooden base that HE3D is using.
One Complaint
This is a great little night light that i can use to build and print different light fixtures to install this into. I have no complaints with the HE3D Led Circuit board moon night light, but only one suggestion please make sure to encapsulate the circuit board, It is very small and fragile and is going to be handled at least 2 times maybe more.
Here is another great article on Tiamet3D Ultra Nano Diamond Filament Review have a look tell us about your experience.
